The DJI Inspire 3 is here!
GPC, Inc has designed the ultimate case to meet all your requirements for a day on the production set. We have 44 cavities versus 30 in virtually the same size case as the your included case. This case is packing all of the necessary accessory cavities in this rugged case, including space for 2 High-Bright Monitors, Grips and 3 CH Follow focus.
To make sure you can fly all day on location there are 18 TB51 batteries, 6 WB37 batteries and 8 PROSSD Memory Sticks safely packed into 2 Pelican Micro cases that are included with case. Lastly, this case accommodates the Inspire 3 in the Travel mode, but still allows for quick deployment with all immediate launch items in the top tray and all the back up in the lower tray. This case configuration even though it is a smaller case stores more accessories than the landing mode.
*Final design subject to change. Case accommodates props on; not shown in photos
*Accessories Not Included*
DJI Inspire 3 Travel Mode Case
- TOP TRAY:
- 1 DJI Inspire 3 in Travel Mode (Props Attached; Not shown in photos yet)
- 2 DJI RC Plus Controllers with DJI 3 Pt lanyard bracket
- 4 TB51 Batteries (Including 2 installed on I3)
- 4 WB37 batteries
- 2 Pelican Micro Cases Each Storing 4 PROSSD Sticks (2 Pelican Micro Cases Included)
- 4 Lens Storage Cavities (1 being a spare at this time)
- Gimbal/Camera Storage
- High Bright Monitor with or without Grips
- 3 CH Follow Focus (cavity block is removable for more misc. accessories)
- High-Bright Monitor for use with 3 CH Follow Focus
- Transmission System (Transmitter)
- 3 Accessory/Cable Cavities (1 under I3 arm)
- 1 Spare Props Cavities (under I3 arm)
- BOTTOM TRAY:
- 14 TB51 Batteries
- 2 TB51 Charging Hubs
- 2 WB37 Charging Hubs
- 2 WB37 Batteries
- Two Pelican Micro Cases Included
- Water-jet precision cut with closed cell foam to resist water and dust infiltration.
- Our custom foam is housed in a durable SKB military spec case used by military and industrial leaders.
- Made in the USA, Shipped Worldwide
- Industrial strength injection molded pull handle
- In-line skate style wheels for easy transport
- Padlock holes include stainless steel padlock protector clips
- Waterproof and dust tight design (MIL-C-4150J)
- Molded-in hinge for added protection
- Trigger release latch system
- Snap-down rubber over-molded cushion grip handle
- Ambient pressure equalization valve (MIL-STD-648C)
- Resistant to UV, solvents, corrosion, fungus (MIL-STD-810F)
- Resistant to impact damage (MIL-STD-810F)
- Lifetime replacement guarantee
- Remember! - If it doesn't say GPC in the foam, it isn't guaranteed!
|Exterior Length||31.75 in|
|Exterior Width||24.5 in|
|Exterior Depth||12.25 in|
|Interior Length||29 in|
|Interior Width||22 in|
|Interior Depth||10.52 in|
|Weight||30 lb||0.00 oz|
|Shipping Weight||35 lb||0.00 oz|